Single Channel Gas Detection Controller The Beacon 110 is a powerful, low cost fixed system controller for one point of gas detection.  An external reset switch allows the alarm to be silenced from outside of the controller housing. Continue reading “Single Channel Gas Detection Controller” »
	2 Channel Wall Mount Gas Detection Controller This low cost fixed system controller is designed to accept up to two points of gas detection. It is capable of connecting directly to a variety of gas sensors. The Beacon 200 can also accept any 4-20 mA transmitter (2 or 3 wire, 24 VDC). Continue reading “2 Channel Wall Mount Gas Detection Controller” »
	4 Channel Wall Mount Gas Detection Controller The Beacon 410 is a highly configurable, microprocessor-based, flexible and easy to use 4 channel gas monitor. It simultaneously displays the gas type, readings, and status for 4 channels of gas detection.  A digital Modbus interface for remote logging of data via a Modbus network comes standard. Continue reading “4 Channel Wall Mount Gas Detection Controller” »
	8 Channel Wall Mount Gas Detection Controller The Beacon 800 is a versatile, low cost fixed system controller for one to eight points of gas detection.  The 2 large digital displays have backlighting and easily identify both the gas type and the gas concentration for all 8 channels simultaneously. The Beacon 800 is housed in a NEMA 4X rated case for a weather tight seal Continue reading “8 Channel Wall Mount Gas Detection Controller” »
	Intelligent Gas Detector The new Model GD-70D smart gas detection transmitter series sets a new standard for performance, flexibility, and versatility. The long life high capacity pump and wide variety of sensing elements are replaceable in a few seconds, with no tools required. The smart sensors retain all calibration and sensor-specific data in non-volatile memory, so sensors can be hot-swapped in the field with no programming required. Continue reading “Intelligent Gas Detector” »
	Oxygen Sensor Ideally suited for Laboratory environments, the Oxygen Sensor has been designed to be used in conjunction with a Beacon Controller.  Matched with a  Siren and Strobe the O2 system can be used as a stand alone system or integrated into a full BMS System. Continue reading “Oxygen Sensor” »